1.Overview
Rectangle Compartment Side Way Action Type
Jig has two types. One is left compartment
side way jig, another is right compartment
side way jig. The jig has fixed screen. It
is available in separating metallic ores,
such as tungsten and gold placer deposits as
well as beneficiated tin ore, which not only
can be separated fine materials, but coarse
also. The largest feed size is 6-8mm but it
can be 12mm in few cases.
2.Structure and Description
LTS300×450 Rectangle Compartment Side Way
Action Type Jig is mainly composed of jig
box, drive device, water distribution,
diaphragm and bibcock. There are two jig
buckets with different sizes and each
diaphragm is divided into jig area and
diaphragm area by clapboard. The rubber
diaphragm pumping to make medium (water)
moving is the jigging course. The triangle
belt drives big belt pulley by electromotor
so connecting rod of the eccentric gear and
rocker are up and down moving. Another
connecting rod is connected with the rubber
diaphragm which is moving up and down to
jig.
Based on the size of ore, we can change the
stroke of connecting rod and choose
different stroke to make the best jigging
effect. The method of altering stroke per
minute is to exchange a smaller belt pulley
but there are two strokes per minute:
322r/m; 420r/m. The method of choosing
stroke is to loose bolt and screw cap, take
out bowel and move the relative place
between eccentric adjusting sieve and
eccentric shaft so there are 11 different
strokes (0-25.3mm).
Because of a sieve added on the working
screen, the jig can be processed the uneven
sizes of material. (note: the sieve can be
requested to supply or not). After the feed
ores are sent to jig chamber, the ores are
separated to different layers in the medium
by the pulsation of diaphragm. The light but
weight is sank to the tank of jig bucket
through the spaces of materials of
artificial bed layer and its sieve holes but
the coarse but light is washed to the
discharge end of screen by medium. Because
the back jig chamber is lower 50mm than
front jig chamber, the light ores is
overflowed through front jig chamber to the
back chamber and jigged again. If needed,
the place of end plate can be adjusted to
control the discharge amount. The
concentrate in tank can be discharged by
discharge tube regularly.
3.Technical Parameters
|
Mineral processing
equipment
